
Pertronix Ignitor is a points replacement system
which replaces your old points and condenser
with a breakerless solid state high performance
electronic ignition system at a low price that fits
entirely under your stock distributor cap.
Pertronix Ignitor will give your engine better
fuel economy, more horsepower, longer plug life
and all the advantages of an electronic ignition system.
Pertronix Ignitor installs in less than 30 minutes in most cases.
A solid-state electronic system ... "never change points again!"
Test results show the Ignitor delivers twice the voltage
to the spark plugs, increasing horsepower, fuel economy
and plug life. A 2:1 improvement over point type systems in
current fall time for increased coil output. System is designed
for use with most point-type coils, optimal performance achieved
when used with our Flame-Thrower 40,000 volt coil.
Rotating cobalt magnets, mounted on the distributor shaft,
trigger an electronic switching module (Hall effect integrated circuit)
...no points to burn, pit and corrode ...no moving and rubbing parts to wear out.
Electronics are molded in epoxy, eliminating deterioration from dirt, oil, grease or moisture
(better foul weather performance). Fits entirely inside the distributor,
no "black box" to clutter your engine compartment.
Stable timing... no need for any adjustments. No complicated wiring makes installations easy.
Compatible with 12-volt negative ground systems
(some applications available for 6-V negative ground and 6 and 12-V positive ground systems)
Works great in stock point-type distributors as a trigger for multi spark CD ignitions,
eliminating the need for expensive aftermarket distributers

The perfect compliment to our Pertronix electronic Ignition systems.
These high powered coils pump out a huge 40,000 Volts to your plugs,
maximising energy and reliability over the full RPM range
The extra output from the Flamethrower coil allows for larger spark plug gaps.
Greater fuel efficiency and higher power output.
Pertronix Ignitor Points Replacement Systems are model specific.
If you are unsure of the model required for your application you can check the pertonix catalogue or copy and fill out this Product Specific Information template and
email it to pertronixsales@xtra.co.nz
Product Specific Information
Vehicle Manufacturer (eg Ford Nissan etc)
Vehicle Model ( eg Mustang etc)
Vehicle Year
Distributer Manufacturer ( eg Bosch Lucas etc)
Distributer Model Numbers ( Require ALL numbers)
Engine Year
Number of Cylinders
Present Coil manufacturer and resistance (If known)
Or for other enquiries and performance products visit www.philspeed.co.nz
Or phone 03 327 2702 Please make sure you have the make and model numbers of the exact distributer you wish to convert before ringing
Sometimes you may have to remove and clean the distributer to indentify it
All products including non stock special order can normally be supplied in 7-14 days
We freight with Poste Haste and New Zealand Couriers
Track and trace NZ wide $8