Pen Modification

 This is my another new modification.  Being the most superior than other Super Grip G3 series, i found it very good to spin with.




Full Specification:
Full name: Pilot Super Grip G3 Revolution Xero
Length: 18.3cm
Width: 1.02cm on the barrel
Weight: 14g
Type: Retractable
Cost: 300yen ($3.00)
COG: 2.03mm away from center


Pros:
Much heavier than Super Grip G3: Generation II
RETRACTABLE
More momentum
Balanced
Longer
Grips on both sides

Cons:
Um, it doesn't look cool?

Pens Needed:

-Pilot Super Grip Knock (Ballpoint pen)
-Pilot G3 (Gell pen, it doesn't matter if you have metal tip or not)
-Another Pilot G3 (Just the cap)


Tools Needed:

-Handsaw (or Sissors)
-Ruler

note: In the tutorial, there are "#1" and stuff, that means the next 11 things.  If it says "#3-8" or something like that, it means that they are talking about combined parts.

1. insert (11.4cm)
   
2. G3 cap: Cut it from the tip so that it's 3cm long.
3. Another G3 cap: Cut it from the tip so that it's 4cm long
4. G3 barrel (Dont remove the grip)
5. Super Grip knock part: Cut the barrel so that black part comes out about 1.7cm. Cut the Super Grip's grip so that it's 1.5cm long and put it on the back part of Super Grip knock (like in the picture).
6. Super Grip Ink Tube
7. Tooth pick: Cut it so that it's 4.6cm long
8. Super Grip Grip: Cut the lined part so that it's 1cm long
9. G3 tip
10. Super Grip spring
11. mini insert (3.3cm long)

Assembly

1. Put #8 around #3 from the thinner part.  Put #10 into #9 and put them into #3-8. Then put #11 in.
2. Put #2 from where the bump is into #5, and put it into #4.  Put #1 into #4 from the colored part first and keep putting it in so that it overlaps the 5mm part of #5.
   
3. Put #7 into back of #6 from the pointy part. Then put that into #4.
4. Put #3-8-9-10-11 on #4 until it makes a "click" Sound.
5. You are finished. Spin away!
   

Note: You might want to adjust the inserts so that it would look good.

Go spin the pen and write with it.