Pen Modification

This is another new mod I made. It's not retractable nor writeable.




Specifications:
Full name: Japanese Lakubo Momentum MX
Weight (with insert): 12.5g
Length: 18cm
Thickness: 9.5mm
Type: Spin only
COG: Complete Center
Cost: 300yen ($3)


Pros:
-Weight is very close to RSVP MX
-Um, looks cool?
-Two inserts because MMX
-Easy to mark COG on inserts because it's center
-VERY BALANCED!

Cons:
-Not writeable like my other mods
-Probably wouldn't be able to make it in USA
-Not suited for Infinity tricks



Pens needed:
-Uniball Lakubo
-Sailor Needle Line
-Pilot G2 OR Pilot G-Knock

Tools needed:
-Hand saw
-Sandpaper
-Nail Cutter (If your nail cutter have sanding, then you won't be needing sandpaper.)

1-Uniball Lakubo Back part: Poke a hole in it so that the inktube can completly go through.
2-Sailor Needle Line back part
3-G2 / G-Knock barrel-Cut it so that it's 4.5cm long. then sand it
4-Sailor Needle Line cap: Use a nail cutter to snap off the clip then sand it
5-Sailor Needle Line Grip
6-Uniball Lakubo Barrel: Cut the front tip (use hand saw because it's not removable). Then remove the Grip (Grip is glued on, so pull hard) and sand off the bumpy part.
7-Sailor Needle Line tip
8-Uniball Lakubo Inktube



Assembly

Note: It would say #1 and #4 or something like that. that means the parts above. If it says #1-4-8 or something like that, that means the combine part of #1,4,and 8.

1. Put the insert into #6. Then put #7 on the front part of #6. Wrap the smaller insert around the thin part of #6 and little of #7. Then put #3 on it. If you are worried about the #7 falling off, (Which shouldn't if you put insert) then use super glue to keep it on.
   
2. Put #2 into #4 then put #5 into #4.
3. Put #8 in #6 reversed, and put #1 to cover it. Now the inktip should be popping out of #1.
4. Put #2-4-5 on #1
5. You are done! Spin away!