The unit shown below is made using the directions for the Betta Wall I obtained from Ken and Wanda Newby (Riverbend Bettas).  The orginal plans can be found here.  I have modified it slightly to include the second wall.  I would like to thank the Newbys for allowing me to use the plans for their system.

This is a rendition of the Barracks I am building.  It is not completely finished yet.  I still have to purchase and install the main water pump, the UV sterilizer and the remainder of the Beanie Boxes.  Once I have it completed I will post an actual picture.

Once this system is up and running, the unit will continuously supply fresh filtered water to each container.  The water will overflow through a slot in the containers, drain into the gutter below and drain back into the sump area where it will be filtered and pumped back into the containers once again.  This unit is fashioned in a manner that I can shut off all water flow to a specific side or row of the barracks.  If I only need to run as few as 6 containers or all 109 it will be easy to accomplish just that.

The smaller wall on the left side is where I will house my Breeding Stock.  The right side is where I will house my juvies as they grow and start to show aggression.