Apex Driving School
Excellent Pass Rates at an Affordable Rate
From 1st July 2008, there are an extra 6 show me , tell me questions, see below
How you would check to see if your horn is working?
How would you check to see that the power assisted steering is working correctly before starting a journey?
How would you check that the brakes are working before starting a journey.
How would you check the parking brake (handbrake) for excessive wear, make sure you keep safe control of the vehicle
How would you check that the brake lights are working on this car.
How would you check that the direction indicators are working.
How would you would check that the headlights & tail lights are working.
Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.
Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.
Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level.
Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil. Open the bonnet, identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer level.
Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid. | Check is carried out by using control (horn button/switch)
If the steering becomes heavy the system may not be working properly. Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.
Apply footbrake firmly. Demonstrate by applying parking brake (handbrake) so that when it is fully applied it secures itself, and is not at the end of the working travel.
Operate brake pedal, make use of reflections in windows, garage doors, etc, or ask someone to help.
Applying the indicators or hazard warning switch and check functioning of all indicators.
Operate switch (turn on ignition if necessary), then walk round vehicle.
No cuts and bulges, 1.6mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference.
Manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold, don’t forget spare tyre, remember to refit valve caps.
Identify high/low level markings on header tank where fitted or radiator filler cap, and describe how to top up to correct level.
Identify dipstick / oil level indicator, describe check of oil level against the minimum/maximum markers.
Identify reservoir and explain how to check level.
Identify reservoir, check level against high/low markings. |
NEW 1/7/2008
How would you clean the windscreen using the windscreen washer and wipers
How would you set the demister controls to clear all the windows effectively, this should include both front and rear screens
How would you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash
How would you switch your headlight from dipped to main beam and explain how you would know the main beam is on whilst inside the car Show me how you would switch on the rear fog light(s) and explain when you would use it/them. Tell me how you would know if there was a problem with your anti lock braking system | Operate control to wash and wipe windscreen (turn ignition on if necessary.
Set all relevant controls including; fan, temperature, air direction / source and heated screen to clear windscreen and windows. Engine does not have to be started for this demonstration
The head restraint should be adjusted so the rigid part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of the head as is comfortable. N.B. Some restraints might not be adjustable
Operate switch (with ignition or engine on if necessary), check with main beam warning light
Operate switch (turn on dipped headlights and ignition if necessary). Check warning light is on. Explain use
Warning light should illuminate if there is a fault with the anti lock braking system |
